11/10/2023 0 Comments Octoprint on raspberry pi zeroIn short of the post above, you install pip and some packages, install Octoprint via pip, then download the systemd unit, modify the user and executable to your Octoprint, add yourself into the necessary group for interacting with serial port, everything works well. Also, remember to configure your wifi as well. There is a very good post with instructions inside, just refer to it. I installed Debian as my system, and install Octoprint. There is nothing I could say better than referring to the official documentation. IMG_1639.jpeg 3024×4032 2.91 MB Install System on Radxa zero and Octoprint I then thus use some jumper wire, connect with UART_AO_B instead to physically solve this issue. The problem is that u-boot allows interrupts during boot and is also outputting messages during boot, the messages are captured by 3D printer board, and it sends some responses, thus blocking the boot process. I will cover each step in the following section, but I will first describe the issue that I solved with a hack mentioned at beginning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |